Sprinkler Heads sometimes have to be replaced due to damage with various causes. If you use a sprinkler in a garden or park, then this is an interesting discussion to see until it’s finished. We will discuss about how to replace a sprinkler head easily. So, what causes the damage to the Sprinkler Heads?
Among objects that can damage the Sprinkler Heads are lawn mowers, snow, snow plows, dirt, sand, debris, and freezing weather, all of which can damage the Sprinkler’s head in various ways. Fortunately, to replace Sprinkler Heads is not a difficult business to do. In this article, we explain how to replace a sprinkler head in five steps.
1. Determine what kind of Sprinkler Heads to buy
Look at the sprinkler heads, which brands and what brands they make so you can easily find a replacement. This is information that you must know and must remember in your head. Note also the size of the sprinkler heads model listed.
However, if your sprinkler’s head is badly damaged as it was stepped on an ox, and you cannot read its model and size, then look for another sprinkler in the park and see the model (if you use the same sprinkler more than one in the park).
– Rotor Heads
What’s wrong with the rotor head? If you have a rotor head, you can also get information regarding here. the rotor head must be the same as before, if you use a fully rotating head, then look for the same or vice versa, because we will replace with the same one as it was damaged.
Get the right nozzle size from one rotation that has the same spray.
– Purchasing Parts
To buy a replacement for a damaged part, check the main home improvement chain, if you can’t get the information there, try searching the internet.
2. Dig up sprinklers that have been damaged in the park
To scrape the top soil, use a shovel around the sprinkler head. Do not dig too deep and cut too deep because it can damage the water hose.
After cutting 1 foot round or square. Please remove the sod layer carefully. Lift straight up, use your hands to take the ground around the sprinkler’s head, can also use a hand shovel. Discard the soil around the sprinkler head until your hands fit on both sides of the sprinkler.
3. Remove the old sprinkler head
Open the old sprinkler head by turning it counterclockwise. Be careful not to get dirt into the connection when the old head has been removed. If everything is done, then put the new sprinkler head in place.
If dirt such as soil enters the connection, then enter the sprinkler’s head by letting the water come out until all the dirt is removed.
See more: What is Horsehair Plaster?
4. Screw on the new head
When the connection is free of impurities, it is time to attach the sprinkler head to the end of the thread and replace the dirt and soil. If the sprinkler is damaged by snow or a lawn mower, then to install a new one, dig a hole a little deeper and make sure the sprinkler’s head is not more than 1/2 inch above the ground. This is useful to prevent the entry of dirt and clogged with dirt.
Before filling the hole again with the soil, check whether there is a leak or not. This is very important so you don’t have to dig twice.
5. Set the Nozzle
The final step, lift the lid and hold the stem carefully with your fingers. Can also use special tools that are included with the rotor head. Insert the nozzle into the stem and screw it in there.
To prevent your sprinkler head from being damaged or clogged quickly, clean it as often as possible.
That’s how to replace a sprinkler head easily. Don’t forget to always clean the edges of the sprinkler to prevent it from wasting and costing you.